Building a Campfire There are many different campf Essay Example For Students

Building a Campfire There are many different campf Essay ire structures that can be built to start a fire while camping. The most common are the teepee, log cabin, dugout, and tunnel structures. Almost anyone can build these fires if he or she follows some key points. A fire needs three elements: air, fuel, and an ignition of some kind. For a campfire the air element is easily accessible; its the air a person breaths or oxygen. Fuel is equivalent to wood. Sometimes lighter fluid is used to start big fires immediately, but usually when dealing with a campfire the fuel is wood. Ignition can come from a spark, match, or lighter. It is anything that initially starts the fire. Going deeper into wood, there are three categories to classify it under. Kindling is the stuff that is easiest to burn. It could be leaves, dryer lint, or very small twigs. The next size of wood is sticks and small logs. These will range in size from one half inch to two inches in diameter. Anything larger than this is classified as the fuel. The fuel is the big logs that will burn for hours. When a fire is started it needs to be built like this: kindling first, then sticks and small logs, and then the fuel, once the fire is going good. Using this technique with the following fire structures will ensure hot easy fires. The teepee style structure is probably the most used and easiest to build, but doesnt necessarily result in the hottest or longest burning campfire. To build this fire think about the name teepee. The end result before burning this structure looks like an Indians teepee (If the teepee shape is not familiar, then envision a conic shape). Start by placing the intermediate size wood or sticks in the ground in a circular shape about eight to twelve inches in diameter, leaning the tips of the sticks together in the center. The sticks should already start to resemble a teepee shape. Continue layering the walls of the teepee with more sticks, but not too thick, because air needs to be able to pass through the walls easily. Leave a hole on one side large enough to place kindling inside the stick walls. This hole is also left to light the kindling from the inside and may be filled in once the fire is lit. Once this is completed, the structure should be a recognizable teepee or cone shape. The kindling should be lit on the underside inside the teepee walls through the hole that was left. Due to this easy structure, when the smaller sized twigs start to fall in and burn up, larger sized sticks can be placed on the outside in the same manner as before, keeping the teepee shape. A log cabin campfire structure is just as easy to build as a teepee, but must be built more accurately in order for the fire to burn efficiently. In the same way the teepee name resembled its shape, so does the log cabin. Its built by placing two sticks parallel to each other, and than another two on top parallel to each other also, but perpendicular to the previously laid sticks. When viewing the structure from the top it should look like a square. Continuing this procedure while sliding each layer to the middle slightly will produce a pyramid shape without a top. The end result will appear to be a miniature log cabin that grows narrower towards the top. In the center of this cabin is where the kindling is placed. When lighting this structure, a hole might have to be dug under one side if there isnt enough clearance to light the kindling from the bottom side. After its lit, sticks can be laid across the top like a roof, and then eventually the fuel will be laid on top too. The next two structures are to be built when there isnt a fire ring in the campsite and a hole needs to be dug to contain the fire. The first of the two, the dugout, is started by digging a hole. The initial hole should be slightly oval in shape and reach .